OmniRange-C5 ESP Ghost Firmware Flash Guide ⚠️ Note: Some features may not be fully supported due to hardware limitations. 1. Access Firmware Download Page Use Chrome or Edge browser to visit: 👉 https://flasher.ghostesp.net/ Ensure that no other applications are using the serial port (e.g., serial monitor tools, Arduino IDE). 2. Enter Bootloader Mode Follow these steps carefully: Make sure the power switch on the right side is OFF Press and hold the rear red BOOT button While holding the BOOT button: Insert the USB cable Turn ON the power switch Release the BOOT button ✅ Success Indicator:The screen turns dark gray, indicating Boot mode is active. 3. Flash Firmware Follow the on-screen instructions on the flashing website to complete firmware installation. 4. Reboot Device After flashing is complete, restart the device If the screen shows ESP Ghost Logo, the flashing is successful 5. Purchase link 👉 omnirange-c5 FAQ Q: The webpage fails to load or flashing fails? A: Try the following: Clear browser cache Switch browser (Chrome recommended) Replace USB cable or port Close any software occupying the serial port
